Home › Service Areas › Stanwood › Chimney Chase Cover Replacement
Chimney Chase Cover Replacement in Stanwood, WA
Stainless chase covers for Stanwood's SR 532 plats and Camano Island homes, starting at $299. Free quote and price match plus 10-25% off.
- Serving Stanwood & Snohomish County
- Free 2nd-opinion quotes
- Price match + 10–25% discount
Free Chimney Chase Cover Replacement Quote in Stanwood
We'll confirm a time by phone or text.
The newer homes in Stanwood, uptown along SR 532 and in the plats between downtown and the Camano Gateway Bridge, were typically built with factory-built fireplaces inside sided chases, and the galvanized chase cover on top is the weak link. Covers on Camano Island and at Warm Beach sit in salt-laden air and wind-driven rain, and the zinc coating gives out at the seams, screw heads and pipe collar sooner than it would inland. The first sign is a rust streak down the siding; the next is water on the firebox floor and a musty smell when the fireplace has not been used.
We measure the chase, fabricate a stainless cover with a cross-break so it sheds water instead of ponding, a drip edge that clears the siding, and a new storm collar at the pipe, then install it and check the chase sheathing for rot while the top is open. Chase cover replacement in Stanwood starts at $299 with a free quote, and a competitor's bid gets a free second opinion plus a price match and 10-25% off. Stanwood is about 65 to 75 minutes from Renton, so we group cover jobs with our Arlington, Marysville and Camano stops and often measure the same day. If you are not happy with the cover, we are not done.
Symptoms
Signs Stanwood homeowners notice
- Rust-colored streaks down the siding below the top of the chimney
- Standing water or rust pooling on top of the chimney after rain
- Water dripping onto the fireplace or staining the ceiling beside it
- Soft, swollen, or peeling siding and trim near the top of the chase
- A cover that rattles or lifts at the edges in wind
- Visible rust holes or a sagging center in the metal lid
Stanwood Conditions
Why this happens in Stanwood
A chase cover at the north end of Puget Sound sits in water for most of the year. Regional normals from Sea-Tac show 40.34 inches of precipitation annually, about 73 percent of it between October and March and only about 3 inches across June through August, so a flat galvanized pan in Stanwood ponds through the wet season and dries only in summer. The open exposure on the flats and the shoreline drives rain under the cover's edge and against the storm collar, the two places a builder-grade cover fails first.
Once a seam rusts through, the chase framing underneath starts the same freeze-thaw cycle that damages masonry: around 60 days a year that touch 32F with lows averaging about 37F, so soaked sheathing freezes and thaws instead of staying frozen, and it rots faster than it would in a colder, drier place. Replacing the cover when the rust streaks first appear keeps the job to a cover alone, which is why we ask for a photo of the siding when you call.
How It Works
Our chimney chase cover replacement process
Measure the chase
We measure the chase, the flue pipe diameter and position, and the skirt height so the new cover fits without gaps.
Fabricate the cover
The replacement is made from stainless steel or aluminum with a cross-break, raised collar, and a drip-edge skirt over the siding.
Remove the old cover
The rusted lid comes off and we inspect and dry out the top plate. Minor wood damage is addressed before the new cover goes on.
Set and fasten
The new cover is fastened through the skirt into the sides of the chase, never through the top, and the collar is sealed to the flue pipe with high-temperature sealant.
Cap and check
We reinstall or replace the flue cap, confirm the storm collar is sealed, and photograph the finished top for you.
Full details, options and pricing factors on the main Chimney Chase Cover Replacement page.
Need chimney chase cover replacement in Stanwood?
Call now or request a free quote — we confirm by phone or text.
☎ 206-453-2045 Request a QuoteQuestions
Chimney Chase Cover Replacement in Stanwood — FAQ
Does a chase cover on Camano Island need to be stainless?
We recommend it. Island and Warm Beach covers face salt air plus rain driven off the water, and a galvanized replacement would start rusting again at the same seams. Stainless does not need a coating to survive that. Our chase cover replacement starts at $299, the quote is free, and Camano is reached by road over the Camano Gateway Bridge, no ferry.
How do you handle a Stanwood chase cover job when you are over an hour away?
We measure on one north-county trip, fabricate the cover to your chase dimensions, and install on the next. Stanwood, Camano, Arlington and Marysville run together on the same days, so the gap is short. If the old cover is leaking now we put a temporary cover over it on the first visit so your fireplace stays dry in between.
How soon can you do chimney chase cover replacement in Stanwood?
We confirm a time by phone or text after you request a quote; same-day service is often available for urgent problems in Stanwood and the rest of Snohomish County.
Other services in Stanwood
Chimney Chase Cover Replacement nearby